Shop Now

Click to Enlarge

SPB Section Wedge Belt Optibelt

SPB2650 / 2650mm Inside / 2672mm Outside

Stock Code:

SPB2650_OPTI

$108.77 incl GST

Stock Locations

Ballarat:

4 In Stock
Shepparton:

Special Order

Make an Enquiry

Add to Favourites

Description

DESCRIPTION

SPB Section Wedge Belt Optibelt

SPB2650 / 2650mm Datum / 2672mm Outside

The wrapped optibelt SK wedge belt was developed especially for mechanical engineering, where it replaces its predecessor, the classic V-belt. In comparison, it transmits approximately 50 % more power and thus enables more compact and therefore more cost-effective drives when purchasing new ones.

The wrapped optibelt SK wedge belt has the characteristics of the excellent Optibelt S=C Plus with an efficiency of almost 97 % and can be used in the set without further measurements.

View S=C Plus flyer

Replacing a classic profile

In the case of existing drives with a classic profile, e. g. B/17, this can be replaced by the SPB wedge belt profile. A prerequisite for this is the observance of the minimum disc diameter, which is higher than that of the classic V-belt due to its increased design for wedge belt of the same width. Pulleys suitable for wedge belts must also be used.

Quality Attributes / Advantages

The wrapped wedge section V-belt can be used on agricultural and industrial applications
Standard v belts are manufactured from a specially formulated rubber and reinforced high strength polyester cords for uniformity and strength
For use in sets without measurement (S=C Plus)
Considerable energy-saving
High efficiency
Wedge belts manufactured according to DIN/ISO/BS standards
Premium performance
Oil and heat resistant
Excellent performance/cost ratio
Suitable for dirty/dusty environments
Tolerates mild clutching or drive slip

Construction

Wedged cross-section
Fibre-loaded compound for improved belt stability
Sides provide full contact with pulley grooves for uniform loading of cords, uniform wear and increased belt life
Polyester cords for equal load distribution and reduced stress.
Cover is a fabric construction for longer life, providing extended protection to the belt core from oil, dirt and heat
Non self-igniting - the belt will not catch fire from heat build-up, even with severe slippage

Temperature Range

Range: -40°C to +70°C

Please Note - The size of the belt should always be checked with original before purchasing. This is because sometimes different belts are used within the same model/engine variation when there is more than one type of alternator / air compressor / power steering pump / etc. used.

Downloads below